Support Center

Innosilicon Miner Management Tools

Free Windows tools that help you find your Innosilicon miners on the network, change their IP addresses, keep an eye on many units at once and update their firmware.

InnoMonitor

Monitoring and batch management for mining farms. InnoMonitor scans your network, shows the status of every miner in one list and lets you update firmware on many units at once instead of flashing each miner by hand. Available for 64-bit and 32-bit Windows.

For farms with many miners

SetIP

Finds Innosilicon miners on your local network and changes their IP address. Useful when a new miner is connected, when the network settings were changed or when you simply do not know which address a miner received.

For first setup and network changes

A4+ / A5 / A5+ / A6 Manage Tool

A management tool made for the older A4+, A5, A5+ and A6 miners. It helps to configure and maintain these models, which use an older control board and web interface.

For A4+, A5, A5+, A6

Firmware installer

A small utility that installs a firmware file on a miner from your computer. Always choose the firmware that matches your exact model and board type (for example G19 or SOC).

For firmware updates

Innosilicon Control Center

Our free companion app brings everything together: the firmware library for 61 models and variants, user manuals, repair guides, these tools and a live connection to your miner.

All in one place

Where to download the tools and their manuals

All tools listed on this page, their user manuals and the firmware files for every supported model are collected on our Firmware & Tools page. We keep them in one place so that you always get the current, working version.

Tips for using the tools

Run the tools on a computer in the same local network (and subnet) as your miners, preferably connected by cable.
If your firewall or antivirus asks whether the tool may access the network, allow it, otherwise the tool will not see your miners.
Before a batch firmware update, make sure all selected miners are the same model and board type, and keep their power supply stable until the update is finished.
Write down your pool and worker settings before updating: some firmware versions reset the configuration.

Go to Firmware & Tools Contact support

Innosilicon and related model names are trademarks of their respective owner. This site is an independent, unofficial project and are not affiliated with, endorsed by, or sponsored by Innosilicon. Privacy Policy · Cookie settings